Measure Panel Glide Blinds

INSIDE MOUNT

STANDARD WINDOW – INSIDE MOUNT – BLIND IS FITTED INSIDE THE WINDOW OPENING

FACTORY STANDARD DEDUCTIONS

INSIDE MOUNT WIDTH DEDUCTION 0mm
INSIDE MOUNT DROP DEDUCTION 0mm

WIDTH

  • Measure neat internal width of reveal
  • Measure at three width points – top, middle and base of reveal.

DROP

  • Measure at three drop points – left, middle and right of reveal.
  • Use the shortest drop for this product but be advised if window is “out of square”. Blinds can only be made square so if window is out of square it may result in irregular light gaps around the blind. Advise your client.

OUTSIDE MOUNT – Blind Fitting Onto Architrave

STANDARD WINDOW – OUTSIDE MOUNT – BLIND FITTING ONTO ARCHITRAVE

FACTORY STANDARD DEDUCTIONS

OUTSIDE MOUNT WIDTH DEDUCTION 0mm
OUTSIDE MOUNT DROP DEDUCTION 0mm

WIDTH

  • Measure from outside edge of architrave to outside edge of opposite architrave at three points – top, middle and base.
  • Use the largest width measurement.

DROP

  • Measure from top of architrave to base of lower architrave or floor. Measure at three drop points.
  • Use the longest drop measurement.

Outside Mount – Blind Fitting onto Wall

This will occur in situations where there is no architrave or when you wish to reduce the amount of window area that will be covered by the stack up of the blind.

WIDTH

Measure minimum of 50mm past each side of window opening

DROP

If fitting blind into plaster or concrete – measure minimum of 70mm above window opening to a minimum of 50mm below window opening or to the floor.

If fitting blind into brick – measure from top of first brick to a minimum of 50mm below window opening or to the floor.

Download Guide